Control Panel; Display Indications - EdilKamin BERING Instalación Uso Y Mantenimiento

CONTROL PANEL

ON/OFF key
this also serves to confi rm/exit
Selection key: access to regulation menu
(press for 2 seconds)
Key to DECREASE temperature and to scroll back
from the selected data
Key to INCREASE temperature and to scroll for-
ward from the selected data

DISPLAY INDICATIONS

OF
Shut-off phase in progress, duration approx. 10 minutes while the pump continues to work until the
set shut-off temperature is reached (usually 40°C)
ON AC Boiler in the fi rst ignition phase: pellet loading and waiting for the fl ame to light
ON AR
Boiler in the second ignition phase: heating the boiler body and start-up of combustion
Burn Boiler in water exchange heating phase
P1-P2-P3-P4-P5 Level of power, modulated automatically
50....80°C
Level of water temperature desired for system output
Pu
Automatic cleaning of chamber in progress
PROG Timer menu for weekly programming
SET
Menu for setting the clock
SF
Stop Flame: stops functioning for probable lack of pellets
AF Ignition Failed: stops functioning for failed ignition
CP-TS-PA
Control menu available only to Technical Assistance Centres
H1......H9
System in alarm, the number indicates the cause of the alarm
When the boiler is in stand-by mode, the display shows the wording OF and the set temperature.
SCREW FILLING.
The pellet transport duct (screw) has to be fi lled when the boiler is new (on fi rst ignition) or if the boiler has completely user all the pel-
lets.
To activate reloading, simultaneously press the keys
The reloading function stops automatically after 240" or when the key
INSTRUCTIONS FOR USE
, the display will show the wording "RI".
- 46
This indicates the functioning of the circulator
(pump).
This indicates the functioning of the pellet loading
motor
This indicates that the boiler is functioning within the
parameters of the menu (technical assistance centre
only)
This indicates that the timer is active, and that an
automatic time programme has been chosen
is pressed.
-