geberit RE 1 Instrucciones De Servicio página 15

Guarantee
Use
Operating instructions pipe deburrer RE 1
WARNING
Risk of injury from incorrect handling
` Only plug in the mains connector when the tool is switched off.
Unplug the mains connector after use.
` Always route the mains cable from the back of the tool and do not
pull it over sharp edges
` Before putting the tool into operation, remove the setting tools or
spanner
` Hold the tool with both hands
` Do not alter or dismantle the protection device
` Secure the workpiece with a clamp or vice
` Always keep milling cutter sharp and clean
` Do not put the tool down until it has come to a complete halt
WARNING
Risk of injury by switching on inadvertently
` Do not carry the tool with your finger on the switch
` Do not connect the tool to the power supply when switched on
` Switch the tool off in the event of a power failure
` Unplug the mains connector before changing accessories and
putting the tool away
` Unplug the mains connector before starting any maintenance work
on the tool
CAUTION
Damage to the device from incorrect connection
` Only connect the tool to mains voltage as indicated on the
specification plate
The national statutory guarantee applies. For information about
guarantee services above and beyond this scope, please contact
your responsible Geberit sales company directly or visit
www.geberit.com.
Pipes with an outside diameter of 15 mm to 108 mm can be
deburred along the inside or outside edge with the pipe deburrer.
Pipes with an outside diameter of 12 mm can only be deburred
along the outside edge.
Any other utilisation is deemed to be a violation of the intended use.
Geberit is not liable for any damages resulting from this use.
EN
15