geberit RE 1 Instrucciones De Servicio página 17

Operating instructions pipe deburrer RE 1
Selecting the speed
The speed of the pipe deburrer can be set with a setting
knob. The speed range can be adjusted from level A to G,
depending on the pipe material:
• A = lowest speed
• G = highest speed
For high-grade steel pipes, select a maximum of level C
as colourings can result
Select the speed to match the pipe material
Setting the protection device
The protection device can be mounted in two positions:
• Position I - For pipes with an outside diameter up to d
65 mm
• Position I - For pipes with an outside diameter of d 65
mm to d 108 mm
1 Unscrew wing nuts until the protection device is loose
2 Slide the protection device into the required position
3 Screw the wing nuts tight
I
II
EN
17