Remove Base; Fixing The Steel Rails To The Wall - Medion MD 30325 Manual Del Usuario

Remove base

The base of the device is fixed to the rear with six
screws.
1. Undo the six screws with a cross-head
screwdriver.
2. Lift up the device, away from the base.
• See figure 6A in the illustrated manual.

Fixing the steel rails to the wall

1. Select a location on the wall where there is sufficient distance between the LCD-TV and other
objects (see section "Point of use", page 6).
Bear in mind that the hanging elements on the rear of the device will fit into the narrow ends
of the hanging openings in the steel rails.
2. Mark the eight drill holes in the wall with the supplied drill template.
3. Drill the eight holes for the rawlplugs in the wall.
• See figure 1 in the illustrated manual.
4. Insert the rawlplugs.
• See figure 2 in the illustrated manual.
ATTENTION!
The rawlplugs must fit tightly! Do not hang the device on the wall if the
rawlplugs are not tightly fixed.
5. Attach the two steel rails each with four screws. The narrow sides of the hanging openings
must face downwards.
• See figures 3 and 4 in the illustrated manual.
6. Now you can hang the LCD-TV on the steel rails.
• See figures 8 and 9 in the illustrated manual.
EN
39