WALL MOUNTING
You can mount the LCD-TV onto a wall.
Accessories
The following accessories are supplied with the LCD-TV:
2 steel rails, 4 screws, 4 plastic hanging elements, 1 drill template,
1 illustrated mounting manual (applies to several types of device).
You will also need 8 rawlplugs and screws for fixing to the wall (available in trade shops).
Safety instructions for wall mounting
Be certain to adhere to the following safety instructions when mounting the unit on the wall:
• The LCD-TV must only be mounted onto straight perpendicular walls.
• Check before mounting if the load-bearing capacity of the wall equals at least three times the
weight of the device (16 kg). Ask a qualified fitter for advice if in doubt.
• Switch the LCD-TV off before starting with mounting. The mains cable and aerial cable must be
unplugged.
• At least two persons are required to carry out mounting.
• You will require an electric drill and a cross-head screwdriver to carry out the mounting.
ATTENTION!
Make sure that the rawlplugs and screws that you select are suitable for
your wall.
Mounting the hanging elements and the device
1.
Push the supplied M4 x 10 screws through the plastic hanging elements.
The side with the smallest diameter on the plastic hanging elements is to
be found on the outside.
2.
Tighten the screws with the plastic hanging
elements in the correct screw holes on the
rear of the device.
• See figure 5A in the illustrated manual.
38