Tacho/Frequency Meter - Kübler CODIX 923 Manual De Instrucciones

7.8.4.5 Preset
See below 7.8.6.5

7.8.5 Tacho/Frequency meter

7.8.5.1 Mainmenu for the Signal and
Control inputs
Mainmenu for programming the
signal and control inputs
Input polarity
PNP: switching to Plus
for all inputs in common
NPN: switching to 0 V
for all inputs in common
Filter for the signal inputs Inp A and Inp B
maximum count frequency
damped to approx. 30 Hz
(for control with mechanical
contacts)
Input mode Frequency Measurement
Simple frequency
measurement
Inp A: Frequency input
Inp B: no function
Differential measurement
[A – B]
Inp A: Frequency input A
Inp B: Frequency input B
Total measurement [A + B]
Inp A: Frequency input A
Inp B: Frequency input B
Frequency measurement with
direction recognition [Quad]
Inp A: Frequency input 0°
Inp B: Frequency input 90°
Ratio measurement [A / B]
Inp A: Frequency input A
Inp B: Frequency input B
Page 10
Percentage differential
measurement [(A-B) / A in %]
Inp A: Frequency input A
Inp B: Frequency input B
User input
When the MPI input is activated
the display is "frozen" and
remains "frozen" until the MPI
input is deactivated.
Internally the frequency meter
continues running.
When the MPI input is activated
the current frequency for the
preset will be adopted as the new
preset value.
See also 7.9
Lock input
When the Lock input is activated
the programming is inhibited.
When the Lock input is activated
the setting of the preset value is
inhibited.
When the Lock input is activated
the setting of the preset value
and the programming are both
inhibited
7.8.5.2 Mainmenu for configuration
Mainmenu for matching the input
pulses and display
Multiplication factor
Multiplication factor can be
programmed from 00.0001 to
99.9999.
The setting 00.0000 will not be
accepted
Division factor
Division factor can be
programmed from 01.0000 to
99.9999.
The setting <01.0000 will not be
accepted
www.kuebler.com