Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Disposal of the packaging
The packaging bears the Green Point mark.
Dispose of all the packaging materials such
as cardboard, expanded polystyrene and
plastic wrapping in the appropriate bins. In
this way you can be sure that the packaging
materials will be re-used.
Disposal of equipment no longer used
According to European Directive 2012/19/EU
on the management of waste electrical and
electronic
equipment
electrical appliances should not be put into
the normal systems for disposal of solid
urban waste.
Before installation
Check that the input voltage indicated on
the characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the oven door and take out all the
accessories
and
material.
Warning! The front surface of the oven may
be wrapped with a protective film. Before
using the oven for the first time, carefully
remove this film, starting on the inside.
Make sure that the oven is not damaged
in any way. Check that the oven door closes
correctly and that the interior of the door and
the front of the oven opening are not
damaged. If you find any damage contact
the Technical Assistance Service.
DO NOT USE THE OVEN if the power cable
or the plug are damaged, if the oven does
not function correctly or if it has been
damaged or dropped. Contact the Technical
Assistance Service.
(WEEE),
home
remove
the
packing
Outdated appliances should be collected
separately to optimise component material
recovery and re-cycling rates and to prevent
potential harm to human health and the
environment. The symbol of a rubbish
container superimposed by a diagonal cross
should be put on all such products to remind
people of their obligation to have such items
collected separately.
Consumers
should
authorities or point of sale and request
information on the appropriate places to
leave their old home electrical appliances.
Before disposing of your appliance, render it
non-usable by pulling out the power cable,
cutting this and disposing of it.
Put the oven on a flat and stable surface.
The oven must not be put close to any
sources of heat, radios or televisions.
During installation, make sure that the
power cable does not come into contact
with any moisture or objects with sharp
edges
behind
temperatures can damage the cable.
Warning: after the oven is installed you
must make sure you can access the plug.
After installation
The oven is equipped with a power cable
and a plug for single phase current.
If the oven is to be installed on a
permanent basis it should be installed by a
qualified technician. In such a case, the oven
should be connected to a circuit with an all-
pole
circuit
breaker
separation of 3 mm between contacts.
WARNING:
THE
EARTHED.
english
contact
their
local
the
oven.
High
with
a
minimum
OVEN
MUST
BE
27
Publicidad
Capítulos
Tabla de contenido
