Setting The Dial Mode For The Base; Transfer A Call From Base To Handset; Setting The Base Flash Time; Answering Machine - Topcom Butler 2455 Manual De Operación

HANDL. B2455_euro.qxd
Butler 2455
Caution: The handsfree communication is half duplex which means that if the person on the other side of
the line starts to speak, the microphone is muted, so the person can't hear you at that time. Please try to
avoid speaking to each other at the same time.
Note: The handsfree speaker volume is different from the answering machine volume!!

7.3 Setting the dial mode for the base

You can set the base dialling mode in Pulse(P) or Tone/DTMF(T) by the switch at the bottom of
the base.
Caution: The base dialling mode is independent from the handset.
To set the handset dial mode please look at §4.34.

7.4 Transfer a call from base to handset

During base handsfree conversation you can transfer the call to any registered handset by
pressing the paging key
• You can take over the line by any registered handset when pressing the line-key
• Or press the paging key
Note: The handsets will not ring during transfer!!
7.5 Setting the base flash time
You can set the base flash time by the switch at the bottom of the base. You can set it in
100ms or 300ms.
Caution: The base flash time is different from the handset flash time. To set the handset flash time, please
refer to § 4.22.

8 ANSWERING MACHINE

The Butler 2455 has a built-in digital answering machine with a recording capacity of 11 min.
The answering machine can be operated remotely and features the possibility of recording two
outgoing messages (OGM 1 and OGM 2) (maximum of 2 min).
There are 2 possibilities:
- With OGM 1, the caller has the possibility to leave a message
- With OGM 2, only the outgoing message is given without the caller having the
opportunity to leave a message
The max. recording time for each incoming message = 2 min.
An internal voice will state various information, such as day and time of the call, as well as
settings such as VIP code, ringer tones .. The language of the internal voice is stated on the
packaging!

8.1. LED Display

The new message LED
flashes between each long pause indicates how many new calls have been recorded.
If the answering machine is switched off, the On-Off LED
27/2/03 9:01 pm
. The line indicator LED
again if you don't want to transfer the call
will flash if new messages have been received; the number of
28 28 28
Page 28
will start to blink.
does not light.
.