Individual Operation Of The Drum Filter Module - Oase ProfiClear Premium Instrucciones De Uso

- GB -
5.3

Individual operation of the drum filter module

K
If no further ProfiClear Premium filter module is connected to the filter module outlets, the height of the
latter needs to be increased. This ensures the required water level in the filter container. The height of
the pipe bend outlet determines the rise level of the water in the filter container. Based on the physical
principle of communicating pipes, the water balances out to the same level in all containers.
OASE provides a suitable discharge set (Order No. 50949). It consists of two pipe bends/DN 110
adapters with holding plate.
To be able to connect the OASE outlet set, both outlets must be changed to DN 110. Remove the filter
drum for this purpose. (→Removing/fitting the filter drum)
Removing the DN 150 outlet
How to proceed:
6.
L
1. Remove the oval-head screw.
2. Remove the outlet and the sealing ring.
Fitting the discharge set
How to proceed:
3.
M
1. If not already done: Fit the sealing ring into the wall of the container from the outside.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
−
2. Fit the outlet adapter to the sealing ring.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
−
3. Fasten the sealing ring and outlet adapter from the inside with oval head screws.
Tighten all screws diagonally using the cordless screwdriver to ensure that the sealing ring is
−
uniformly applied. Further tighten the screws using a Phillips screwdriver.
4. Fit the pipe bend set together in the specified order and fasten to the outlet adapter.
5. Guide the holding plate over the pipe bend and align the pipe elements if necessary.
6. Insert the screws with expansion seals through the holes from the inside. Screw the holding plate
from the outside to the container wall with cap nuts.
50