Eaton 93PM Guía De Instalación Rápida página 11

The connector locations are shown in illustration 10.
1. Ground
2.
X1:L1 Rectifier input L1
3. X1:L2 Rectifier input L2
4. X1:L3 Rectifier input L3
5. X3:L1 UPS Output L1
6. X3:L2 UPS Output L2
The connector locations of the UPS with the optional internal MBS switch are shown in
illustration 11.
1.
Ground
2. X1:L1 Rectifier input L1
3. X1:L2 Rectifier input L2
4. X1:L3 Rectifier input L3
5.
X3:L1 UPS Output L1
6. X3:L2 UPS Output L2
The MBP and MIS switches are shown in illustration 12.
The UPS gland plates are shown in illustration 13.
1 Top cable access gland plate
2 Bottom cable access gland plate
3 Top signal wiring access gland plate
4 Cable conduit
See illustrations 6.1 and 6.2 for the UPS communication terminals and communication
cable routing instructions. The terminals are:
1. MiniSlot 1
2. MiniSlot 2
3. MiniSlot 3
4. USB device (connection
to computer)
If installing a customer-supplied battery system, install the battery system according to the
battery and battery system manufacturer's instructions and all the applicable national
codes and regulations.
For the battery specification, refer to the Eaton 93PM UPS 100-500 kVA User's and
Installation Guide.
The external battery breaker is a crucial part of the external battery cabinet or rack and
must be placed in it. With the external battery breaker, signal cabling is required for safe
operation of the UPS.
The external battery breakers can be tripped (switched off) by energizing its shunt trip
coils. The shunt trip coils are energized (controlled) through connector X6. The default
voltage of the battery breaker shunt trip coil is 24 Vdc.
7. X3:L3 UPS Output L3
8.
X2:L1 Bypass input L1
9. X2:L2 Bypass input L2
10. X2:L3 Bypass input L3
11. X1/X2/X3:N Neutral
12. X4:BATT+ External
battery +
7.
X3:L3UPS Output L3
8. X2:L1 Bypass input L1
9. X2:L2 Bypass input L2
10. X2:L3 Bypass input L3
11.
X1/X2/X3/X7:N Neutral
12. X4:BATT+ External
battery +
5. Communication cable
conduit
6. Emergency Power Off,
EPO
7.
Relay output
13. X4:BATT- External
battery -
13.
X4:BATT- External
battery –
14. X8:L1 Maintenance
bypass input L1
15.
X8:L2 Maintenance
bypass input L2
16. X8:L3 Maintenance
bypass input L3
8. USB host (connection to
accessories)
9. Signal inputs
10. RS-232 port for service
11.
External parallel connector
EN
9 9