Cisco Linksys WRT160NL Guia Del Usuario página 29

Chapter 3
No Acknowledgement If you want to disable the Router's
Acknowledgement feature, so the Router will not re-send
data if an error occurs, then select Enabled. Otherwise,
keep the default setting of Disabled.
Internet Access Priority
In this section, you can set the bandwidth priority for a
variety of applications and devices. There are four levels of
priority: High, Medium, Normal or Low. When you set the
priority, do not set all applications to High, because this will
defeat the purpose of allocating the available bandwidth.
If you want to select below normal bandwidth, select Low.
Depending on the application, a few attempts may be
needed to set the appropriate bandwidth priority.
Enabled/Disabled
To use the QoS policies you have set,
keep the default setting of Enabled. Otherwise, select
Disabled.
Category
There are four categories available. Select one of the
following: Applications, Online Games, MAC Address,
Ethernet Port or Voice Device. Proceed to the instructions
for your selection.
Summary
This lists the QoS entries you have created for your
applications and devices. Refer to Summary, page 26 for
more information.
Applications
Applications Select the appropriate application. If you
select Add a New Application, follow the Add a New
Application instructions.
Priority Select the appropriate priority: High, Medium,
Normal or Low.
Click Add to save your changes. Your new entry will appear
in the Summary list.
Add a New Application
QoS > Add a New Application
Enter a Name
Enter any name to indicate the name of
the entry.
Port Range Enter the port range that the application will
be using. For example, if you want to allocate bandwidth
for FTP, you can enter 21-21. If you need services for an
Wireless-N Broadband Router with Storage Link
Advanced Configuration
application that uses from 1000 to 1250, you enter 1000-
1250 as your settings. You can have up to three ranges
to define for this bandwidth allocation. Port numbers
can range from 1 to 65535. Check your application's
documentation for details on the service ports used.
Select the protocol TCP or UDP or select Both.
Priority Select the appropriate priority: High, Medium
(Recommend), Normal or Low.
Click Add to save your changes. Your new entry will appear
in the Summary list.
Online Games
QoS > Online Games
Games
Select the appropriate game. If you select Add a
New Game, follow the Add a New Game instructions.
Priority Select the appropriate priority: High, Medium
(Recommend), Normal or Low.
Click Add to save your changes. Your new entry will appear
in the Summary list.
Add a New Game
QoS > Add a New Game
Enter a Name Enter any name to indicate the name of
the entry.
Port Range
Enter the port range that the game will be
using. You can have up to three ranges to define for this
bandwidth allocation. Port numbers can range from 1 to
65535. Check your application's documentation for details
on the service ports used.
Select the protocol TCP or UDP or select Both.
Priority Select the appropriate priority: High, Medium
(Recommend), Normal or Low.
Click Add to save your changes. Your new entry will appear
in the Summary list.
25