Electronic Circuit Board; Electronic Equipment; Safety Devices - EdilKamin INPELLET 49 Instalación Uso Y Mantenimiento

ELECTRONIC CIRCUIT BOARD

RS
soc et
right-hand
ventilation

SAFETY DEVICES

THERMO COUPLING:
located on the smo e e haust, detects the temperature. On the
basis of the parameters set, chec the ignition, wor ing and
turn-off phases.
AIR FLO SENSOR:
Positioned in the suction channel, this intervenes when the
fuel air ow is incorrect, with consequent depression pro-
blems in the smo e circuit.
SAFETY THERMOSTAT ( 50 C):
Intervenes when the temperature within the insert is too high.
Bloc s pellet loading causing the insert to turn off.
ROOM TEMP. DETECTION PROBE:
located on the remote control. lternatively it can be con-
nected up to the electronic board inside the insert.

ELECTRONIC EQUIPMENT

emergency button
rpm smo e
radio module
ntenna
lithium
smo e e pulsion motor
cochlea
left-hand
ventilation
room
temperature
probe
ow sensor
(optional)
thermo coupling
cr
au iliary
ventilation
AUX/RS485 PORT
(connected via optional serial port cable code 640560)
This is a clean, potential free contact, useful for connecting a
telephone combiner or other control devices via an optional
cable.
BACKUP BATTERY
bac up battery is found on the control board ( - olt R
battery).
Its malfunction is indicated with the following messages: (not
considered a defect but due to normal wear-and-tear): "Batte-
ry chec ".
For more detailed information, please contact the DE LER
who has performed the rst 1st ignition.
- 24
-
mains ac
z /-1 %