Bumber Bar P; 5-Point Safety Harness P; Safe2Go Car Seat P; Traveller Car Seat P - Mutsy trans range Manual De Instrucciones

English
hood forwards and the hood tensioners
down. (S)
· To close the hood, press the hood ten-
sioners up and the front of the hood
backwards. (T)
Bumper bar
· Attach the front guard to the frame by
sliding it over the fixing points on the
hood. (U)
· If the hood is not fitted you can attach
the front guard directly to the frame.
· Slide it off the frame to remove it.
· The child can easily be removed from
the seat by freeing the bumper bar on
one side and then moving it outwards.
5­point safety harness
! Always use the safety harness when
placing a child in the stroller seat.
· Use the brake to park the stroller before
placing the child in the seat.
· Attach the hip and shoulder straps to
the strap running between the legs. (V)
· Adjust the straps to fit using the
b uckles. (W)
· Loosen the harness by pressing the
teeth of the central buckle. (X)
· Check regularly to see that the child is
still secure.
· D-rings are provided to allow an addi-
tional strap to be attached.
safe2go 0­9 months car seat (option)
installing the safe2go
· Slide the adapter set over the central
attachment points. (Y1)
! Attach the adapter marked R on the
right and the adapter marked L on the
left of the frame.
· Attach the Safe2go to the frame so
that the child is able to look round.
You will hear a click when the Safe2go
is properly secured. Check that the
Safe2go is secure by testing if you can
14
lift it from the frame.
removing the safe2go
· Press in the buttons on the adapters.
The Safe2go can now be lifted out of
the adapters.
· If you also wish to remove the adapter
set from the frame, press on the lips
below the attachment points and then
slide the adapters up at an angle. (L)
! Replace the central attachment point
cover caps. (M)
Traveller 0­9 months car seat (option)
installing the Traveller
· Slide the adapter set over the central
attachment points. (Y2)
! Attach the adapter marked R on the
right and the adapter marked L on the
left of the frame. Locate the Traveller on
the adapters so that the child is able to
look round.
! Rotate the carrying handle towards the
head end of the seat so that it lies flat.
The Traveller is now locked to the frame.
removing the Traveller
· Place the carrying handle in the verti-
cal position. The Traveller can now be
removed. If you also wish to remove the
adapter set from the frame, press on
the lips below the attachment points
and then slide the adapters up at an
angle. (L)
! Replace the central attachment point
cover caps. (M)
Maxi­cosi 0­9 months car seat (option)
installing the Maxi­cosi
· Slide the adapter set over the central
attachment points. (Y1)
! Attach the adapter marked R on the
right and the adapter marked L on the
left of the frame.
· Locate the Maxi-Cosi on the adapters