Have Work Carried Out By Honsel Service; Replace Wear Parts - Honsel BZ 103 A Instrucciones De Uso

13. Draw in fresh hydraulic oil with the syringe until
the syringe is completely full.
14. Press the air out of the syringe.
15. Push the full syringe onto the adapter.
16. Press hydraulic oil into the setting tool with the
syringe until resistance is felt.
17. Remove the syringe from the adapter.
18. Unscrew the adapter from the opening of the
oil drain plug.
19. Remove any excess oil in the filling area.
20. Inspect the oil drain plug and O-ring for
obvious signs of wear or damage and replace
both, if necessary.
21. Screw in the oil drain plug with O-ring.
The setting tool is ready for operation.
»
5 .5 HAVE WORK CARRIED OUT BY
HONSEL SERVICE
1. Call up the Service check-in on our website.
2. Follow the instructions on the website.
3. Send the tool to the following address:
HONSEL Distribution GmbH & Co.
Friedrich-Wöhler-Str. 44
24536 Neumünster
GERMANY

5 .6 REPLACE WEAR PARTS

WARNING
Unauthorised accessories
Serious injuries or material damage
• Use only OEM accessories
from HONSEL.
• Read and observe the
information in the operating
manual before operating the
machine.
If you wish to reorder a wear part,
the corresponding article number
can be found in our catalogue or via
the product viewer on our website.
Some parts can be found in our
shop www.niet24.de.
Activity
Replace stud collector,
see Chapter 3.1
Replace nosepiece,
see Chapter 3.2
Replace oil drain plug
and corresponding
O-ring
The following wear parts are
inspected and replaced, if
necessary, during the maintenance
of the clamping mechanism, see
Chapter 5.2
Activity
Replace clamping
jaws, see Chapter 5.2
Replace clamping
sleeve, see
Chapter 5.2
Replace guide sleeve,
see Chapter 5.2
Replace pressure
spring, see
Chapter 5.2
Replace vacuum
nozzle, see
Chapter 5.2
Replace front sleeve
O-ring, see
Chapter 5.2
Replace spacer O-ring,
see Chapter 5.2
Frequency
Obvious signs of wear
or damage
Obvious signs of wear
or damage
• When changing the
hydraulic oil, inspect
the oil drain plug
for obvious signs of
wear or damage
• Increased oil loss
Frequency
• Obvious signs of
wear or damage
• The clamping jaws
no longer hold the
fastener securely
enough
Obvious signs of wear
or damage
Obvious signs of wear
or damage
• Obvious signs of
wear or damage
• Length of spring
under 40 mm
• Obvious signs of
wear or damage
• Extraction force
deteriorates
noticeably
• Obvious signs of
wear or damage
• Extraction force
deteriorates
noticeably
Obvious signs of wear
or damage
English | 47