Nordson TEMPUS Manual De Instrucciones página 15

10. Press enter.
The bead length lights turn on and the display
shows all zeros.
11. Do one of the following:
S
To create two equal-length beads that are
positioned the same distance from the leading
and trailing edge of the product, use the up
arrow to set the desired bead length.
S
To create a continuous bead (no middle gap),
use the up arrow to set a bead length value
that is greater than
the end gaps.
NOTE: If the bead length value cannot be
entered (the display remains at all zeros), the
end gap value entered in step 9 is too large
(equal to or greater than the GTO value).
12. Press enter.
The pattern program is saved and the display goes
blank.
13. To create another pattern program, press enter to
return the display to all dashes and then repeat
steps 2 through 12.
To overwrite a program, press enter to return the
display to all dashes and then repeat steps 2
through 12. If you are overwriting an existing
program the display will show values at each step
instead of the zeros or dashes described
previously in this procedure.
Issued 6/02
1
/ the distance between
2
13
6601023
6601019
6601015
Manual 340289C
02
66-TEMPUS-MA-01