Test Or Purge The Guns - Nordson TEMPUS Manual De Instrucciones

2. Press the up or down arrow key to adjust the
program value as follows:
S
To shift the whole pattern forward or backward,
increase or decrease the GTO value.
S
To change the length of the end gap,
increase or decrease the end gap value.
S
To change the length of the beads,
increase or decrease the bead length value.
NOTE: The product length should not be changed
while the line is running. If it is changed, the timer
must be recalibrated.

Test or Purge the Guns

S
With the display showing all dashes, press the up
or down arrow key until the gun test light turns on,
and then press the gun test key.
The gun light stays on as long as the gun test key
is pressed. If the guns do not dispense glue, refer
to Troubleshooting.
Issued 6/02
15
6601029
6601013
Manual 340289C
02
66-TEMPUS-MA-01