Connection And Operation; Fault Symbols - Migatronic FOCUS STICK 120 E PFC Guía De Usuario

Connection and operation

Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for
later use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply.
Please read the type plate (U
1
machine.
0
l
1
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required when
connecting earth cables and
welding hoses to the machine.
) on the rear side of the
2
Connection of electrode holder for MMA
The electrode holder and earth cable are connected to
plus connection (3) and minus connection (4). Observe
the instructions from the electrode supplier when
selecting polarity.
Switch on, press, weld
•
•
•

Fault symbols

overheated.
Leave the machine on until the built-in fan has cooled
it down.
5
4
3
1. Mains connection
2. Power switch
3. Connection of earth clamp or electrode holder
4. Connection of earth clamp or electrode holder
5. Welding voltage
The welding voltage indicator is illuminated for
reasons of safety and in order to show if there is
voltage at the output taps or electrode.
Switch on the welding machine on the main switch
(2)
Adjust the welding current
The machine is now ready to weld
Temperature error
The indicator flashes, when the power source is
2
1
5