Publicidad
Idiomas disponibles
Idiomas disponibles
8.
Rinse the leaked electrolyte (10)
from the sensor (9) and from your
fingers under running water
11
Fig. 6: Remove sensor cap protector (11)
ð There should be no air in the
sensor cap and the electrolyte.
If the measuring results are
unclear during operation then
the sensor cap must be re-
filled. If the problem persists
then the sensor must be regen‐
erated by ProMinent.
9.
Free the two gold electrodes on the
face side of the sensor body from
any remaining electrolyte using a
soft, moistened paper towel
10.
Fit the sensor as described in the
operating manual for the flow
gauge .
9
10
A0128
Assembly
21
Publicidad
Capítulos
