ABB M2303 Manual De Instrucciones página 53

ABB-Welcome
1. The bottom of the device has screw holes and therefore can be fastened to the wall
according to the illustrations above.
2. The bottom of the device can be affixed at the existing flush-mounted box. The size
of the compatible flush-mounted box is shown in the illustrations above.
Wiring
Affix the bottom of the device and connect it according to the illustration. The insulated
section of the cable end must not be longer than 10 mm.
Settings
Set the addresses of the preferred outdoor stations and the address es of the indoor
stations on the jumper. (See Chapter 4.4, Adjusting the device.")
|
— 52 —