Olivetti d-Copia 120D Manual De Instrucciones página 31

7
Copying files for MFP driver installation and parallel interface
setup (This step will start if it was selected in step 4).
After confirming the message in the "Welcome" window, click the
1
"Next" button.
2 A dialog box appears asking you to verify that the USB or parallel
interface cable is not connected to the MFP. Make sure that the
interface cable is not connected and click the "Next" button.
Click the "Next" button in the dialog box to
3
install the MFP driver or Cancel to quit the
installation.
The setup program will start to copy the files.
In Windows 2000, if the following screen appears
while the files are being copied (the message
may appear more than once), click "Yes" in
Windows 2000.
The following screen appears. Click the "Yes" button, and then the
4
Model screen will appear. Select the model number that is the
same as the model name of your MFP and click the "Next" button.
Be sure to select the displayed model number that is the same as the
MFP's model name. If they are not the same, the driver will not be
installed correctly.
OLIVETTI MFP Driver
5 Establish the printer settings and click the
"Next" button.
Select "LPT1" for the port to be used. If "LPT1"
does not appear, it is likely that another printer or
peripheral device is using "LPT1". Check your
other printers and peripheral devices, and change
the port setting as needed so no device is using
"LPT1". If you wish the MFP to be your default
printer, select "Yes". If not, select "No".
When the "Setup has completed gathering all necessary installation
6
information" dialog box appears, click the "Yes" button.
The parallel interface driver is installed.
7 When the "The MFP driver installation is complete." dialog box
appears, click the "OK" button.
The Desktop Document Manager installer will start.
OLIVETTI MFP Driver
d-Copia 150D
OLIVETTI MFP Driver
4
29