Set The Copy Quantity - Olivetti d-Copia 120D Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 315
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the
SPF. If the stream feeding mode has been enabled using user program No.4, the
SPF (
) indicator will blink approximately 5 seconds after the last original has
been fed by the SPF. While this indicator is blinking, any new originals placed in the
original feeder tray will be fed and copied automatically. If the stream feeding mode
has been disabled, the start (
set even immediately after completion of a copy run from the SPF. The default
setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.56).

SET THE COPY QUANTITY

Set the number of copies using the two copy quantity (
from the original table or from the SPF if installed.
• Press the clear (
• A single copy can be made with the initial setting, i.e., when "0" is
displayed.
• Press the right copy quantity key to set the unit digit
from 0 to 9. This key will not change the tens digit.
• Press the left copy quantity key to set the tens digit
from 1 to 9.
) key must be pressed each time the originals are
) key to clear an entry if a mistake is made.
,
) keys when copying
5
49

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

D-copia 150d

Tabla de contenido