Fault / Malfunction Codes - Sime Brava Slim BF Manual De Instalación Y Mantenimiento

Type Nr. Description
Auxiliary TA function
0 = according to TA
PAR 25
1 = TA Antifreeze
2= domestic hot water disabled
PAR 26 Zone Valve / Pump Relaunch Delay
PAR 28 DHW activation delay with solar power
Anti-legionella Function (Only hot water tank)
PAR 29
-- = Disabled
PAR 30 Maximum domestic hot water temperature
Digital / analogue Pressure switch
0 = water pressure switch
PAR 35
1 = water pressure transducer
2 = water pressure transducer (only pressure displayed)
PAR 40 Modulating Pump Speed
PAR 41 ∆T Modulating pump delivery/Return
System pump forcing (only in winter mode)
PAR 47 0 = Disabled
1 = Enabled
PAR 48 INST Parameter set to default
In the event of a fault/malfunction the message "ALL" will appear
on the display with the alarm number eg. "ALL 04" (Domestic
Hot Water Sensor Fault).
Before repairing the fault:
– disconnect the appliance from the mains power by setting the
main switch to "OFF"
– as a precautionary measure, close the gas isolation valve.
Repair the fault and start-up the boiler again.
after having repaired the fault, when the alarm number
NOTE:
appears on the display together with the message
(see figure), press the button
to start the appliance up again.
86
OFF
d
y for approximately 3 seconds
-- = No modulation
AU = Automatic 30
RESET
3.5

Fault / malfunction codes

Type Nr. Description
ALL 02 Low water pressure in system
ALL 03 High water pressure in system
ALL 04 Domestic hot water sensor fault
ALL 05 Delivery sensor fault
ALL 06 No flame detection
ALL 07 Dual sensor intervention
ALL 08 Fault in the flame detection circuit
ALL 09 No water circulating in the system
ALL 10 Auxiliary sensor fault
ALL 11 Gas valve modulator disconnected
ALL 12 Incorrect configuration of the open /sealed chamber
Fault regarding maximum deviation between the 2
ALL 17
NTC heating sensors
ALL 28 Maximum number of consecutive releases
ALL 37 Fault due to low network voltage
ALL 40 Incorrect network frequency detected
ALL 41 Flame loss more than 6 consecutive times
ALL 42 Button fault
ALL 43 Open Therm communication fault
ALL 62 The self-calibrating procedure must be carried out
Fig. 32
ALL 72 Incorrect positioning of the delivery sensor
ALL 74 Fault in the 2nd element of the delivery sensor
ALL 81 Block due combustion during start-up
ALL 83 Irregular combustion (temporary error)
ALL 96 Block due to clogging in smoke outlet
Range U/M Step
0 .. 2 -
0 .. 99 Min
0 .. 30 Min
50 .. 80 -
35 .. 67 °C
0 .. 2 -
%
.. 100
10 .. 40 %
0 .. 1 -
0 .. 1 -
EN
Default
1 0
1 1
1 0
1 --
1 60
1 1
10 AU
1 20
1 0
- 0