Important - Sime Brava Slim BF Manual De Instalación Y Mantenimiento

– press the button > and select "1" (LPG)
Procedure which MUST be carried out after:
– gas conversion
– changing the gas valve following a fault
– changing the the electronic board following a fault.
– go into the parameter section (if not already there) by pressing
the buttons r and t
same time until "PAR 01" (parameter number) and the value
set (0-4) appears on the display
– keep the button t pressed and scroll through the parameters
until reaching parameter "PAR 49"
– press and hold the button
– the modified value will be stored automatically
– keep the button t pressed and scroll through the parameters
until reaching parameter "PAR 70"
– press the button > to set the value at "5"
– the modified value will be stored automatically
92
(for approximately 5 seconds) at the
> to set the value at "49"
– exit the parameter section by pressing and holding down the
buttons r and t
at the same time
until the delivery temperature is displayed.
m

IMPORTANT

To complete this task the user MUST carry out the
following procedure.
Adjusting maximum gas pressure:
– press the button y until "SUMMER" mode
selected
– press button r and set the DOMESTIC HOT WATER SET to
maximum using the button
– press and hold down the buttons
for approximately 6 seconds until the message |b|"Au"|bb
appears on the display alternating with "to"
– open one or more than one hot water tap
– the boiler will start up and the message "P01" will appear on
the display (Adjusting maximum gas pressure)
– press the buttons > or < until the pressure value indicated in
the table appears on the pressure gauge
– once the value indicated in the table has been reached, press
the button y for approximately 2 seconds to confirm the
value which will then flash once.
Adjusting minimum gas pressure:
– press the button r twice, the message "P00" will appear on
the display
– press the buttons > or < until the pressure value indicated in
the table appears on the pressure gauge
– once the value indicated in the table has been reached, press
the button y for approximately 2 seconds to confirm the
value which will then flash once
EN
(approximately 5 seconds)
l has been
>
> and y at the same time