Playing Mp3 Files (Dn-T645 Only) - Denon DN-T645 Instrucciones De Operación

(8) Playing specific tracks in a specific
order
(Programmed play)
• With this function, you can choose any of the tracks
on the disc and program them to play in any order.
• Up to 99 tracks can be programmed.
2 Programming
• Programming is possible when the CD is in the stop
mode.
1. Press the PROGRAM/DIRECT button $0 so that the
" PROG" indicator lights, then use the number
buttons #9 and the +10 button #4 to program the
tracks.
• For example, to program track 3, 12, and 7, press
, , , and .
• Each time a track is programmed, the number of
that track is displayed on the track number
display, and the total program time is displayed
on the time display. If the total program time
exceeds 99 minutes, only the first two digits of
the minutes are display. (The third and / or fourth
digits are not displayed.)
• " 01:--00m00s" appears on the time display
if the PROGRAM/DIRECT button $0 is pressed
when no program is set.
• " Full" appears on the time display if you
attempt to program more than 99 tracks.
2 Playing the programmed tracks
) button t to play the
1. Press the play/pause ( 1 3
tracks in the programmed order.
• " 01:**Tr" , " 02:**Tr" , etc., appears on
the time display when tracks are selected with
the select knob !2 .
2 Clearing the program
1. The entire program is cleared when
PROGRAM/DIRECT button $0 is pressed again in
the stop mode. The program is also cleared when
the OPEN/CLOSE button w is pressed.
2 Presetting Programs
• Programs can be stored in the preset memory.
When a disc for which a program is preset is
loaded, the programmed playback mode is set
automatically.
• Programs can be stored for up to three discs.
1. Follow the instructions under " Programming" to
input the program.
2. Follow the instructions under " (2) Presetting
Procedure" to set the preset mode. (See Page 18.)
3. Turn the select knob !2 to select " 02:Prg1" (or
" 03:Prg2" or " 04:Prg3" ).
4. Press the select knob !2 .
• The character display changes as follows :
[Before change] [After change]
⇒
Prg1 OFF Prg1 ON
⇒
Prg2 OFF Prg2 ON
⇒
Prg3 OFF Prg3 ON
) button u.
5. Press the stop ( 2
• The preset setting mode is canceled and the set
return to the normal mode.
• To play a preset disc :
Load a disc for which a program is preset.
) button t.
6. Press the play/pause ( 1 3
NOTES :
• Programming is not possible with the disc
holder open.
• During programmed playback, tracks not in the
program can be played by pressing number
buttons #4 and #9 .
(9) Displaying the programmed tracks
When tracks have been programmed, they can be
called and displayed on the time display.
1. Press the CALL button #8 .
• The number of programmed tracks appears in
the frame display section.
2. When the button is pressed again, the number of
the programmed track appears in the track display
section, the time appears in the time display
section, and the number of the track in the program
flashes in the frame display section.
• The displayed track can be cleared from the
program by pressing the 0/CLEAR button #9
twice at this time. In addition, if a number button
#9 is pressed, the track corresponding to that
the
number is inserted in the program before the
displayed track.
• If a track is inserted when there are already 99
tracks in the program, the last track in the
program is cleared.
(10) Playing at a different pitch
1. Press the CD pitch control + and – button y to set
the playing pitch.
• The pitch is indicated on the display.
2. Press the PITCH button e.
• Playback begins at the set pitch, and the
" PITCH" indicator lights.
NOTE :
• When the play speed is changed, the sampling
frequency of the digital output signal also
changes, so it may not be possible to receive
digital signals.
PLAYING MP3 FILES (DN-T645 only )
7
There are many sites on the Internet from which you can download music files in MP3 format. These files can
be downloaded following the instructions on the site and stored on CD-R/RW discs which can then be played on
the DN-T645.
The music on commercially available music CDs can be converted into MP3 files on a computer using MP3
encoding programs. When this is done, the data is reduced to approximately 1/10 the original size. This MP3 data
can then be stored on a CD-R/RW disc, allowing you to create a single 12 cm CD-R/RW disc containing about 10
times more music than a normal music CD, that is some 100 tracks or more (*).
* This is an approximately value for MP3 files of tracks about 5 minutes long converted at a standard bit rate
(128 kbps) and stored on a CD-R/RW disc with a capacity of 650 MB.
✽ Recordings you make are for your personal use and should not be used in ways infringing upon the copyright
holder as per copyright laws.
NOTES :
• The DN-T645 is compatible with " MPEG-1 Audio
Layer-3" , " MPEG-2 Audio Layer-3" and " MPEG-
2.5 Audio Layer-3" . It is not compatible with MP1
or MP2 standards.
[Sampling Frequency]
MPEG 1 48 kHz 44.1 kHz
(Call)
MPEG 2 24 kHz 22.05 kHz
MPEG 2.5 12 kHz 11.03 kHz
• When writing MP3 files on a CD-R/RW disc, set
the writing program's format to " ISO9660 level 1"
or " ISO9660 level 2" , " Joliet" or " Romeo" . MP3
files written in other formats may not play
properly. With some writing programs it is not
possible to record in " ISO9660" format. Use an
" ISO9660" format writing program.
• Generally speaking, the higher the MP3 file's bit
rate, the better the sound quality. With the DN-
T645 it is recommended to use MP3 files written
with a bit rate of 128 kbps or greater.
• The writing program may change the positions of
the folders and files when writing the MP3 files
on the CD-R/RW disc, so the files may not be
played in the expected order.
• Make sure to give MP3 files the extension
" .MP3" . Files with extensions other than " .MP3"
or without extensions cannot be played. (On
Macintosh computers, MP3 files can be played by
(PITCH)
adding the extension " .MP3" after the file name
consisting of a maximum of 8 Roman capital
letters and / or numerals when recording them on
CD-R/RW discs.)
• To protect copyrights, no digital signals are output
when playing MP3 files.
• A maximum of 255 folders can be played on the
DN-T645. Folders over 8 layers down, however,
cannot be played. The maximum number of files
is also 999. If there are 1,000 files, only the first
999 are played. (Files other than those with the
extension " .MP3" are not counted.)
32 kHz
• On the DN-T645, folder and file names can be
16 kHz
displayed like titles. Roman capital letters and/or
numerals and " __" (underscores) are scrolled.
8 kHz
(However, a maximum of 31 characters can be
displayed.) In addition, folder and file names using
other symbols will not be displayed properly.
• The DN-T645 is compatible with ID3-tag (Ver. 1.*,
Ver. 2.0).
• It may not be possible to play some CD-R/RW
discs due to dirt, scratches or the disc's
properties.
• Do not apply seals or tape to the label or signal
side of CDs or CD-R/RW discs. The glue could get
on the disc surface, making the disc get stuck
inside the set.
• The DN-T645 is multi-session compatible.
Only music CDs can be played if the first session
is a music CD, and only MP3 files can be played if
the first session consists of MP3 files.
• The DN-T645 is compatible with play lists.
(.m3u of WINAMP Form) (Preset Functions)
NOTES :
• With some writing programs it may not play
properly. In this case, please set to "
PLst=OFF" .
• Play List may require time for reading.
• The maximum number of play lists is also 255.
If there are over 255 play lists, only the first 255
are performed.
ENGLISH
11