Adjustment Of Needle Plate Setting Knob - Janome MyLock 734D Libro De Instrucciones

Janome 734D Instruction Manual
e
r
(A)
e
(B)
www.toews.com
28
q
w
w
q
w
e
q
w

Adjustment of Needle Plate Setting Knob

(Changing to Standard Serging or Rolled
Hemming)
The needle plate setting knob adjusts the position of
the chaining finger.
The chaining finger will move back under the needle
plate when shifting the needle plate setting knob to
the "R" position.
1. Turn off the power switch and unplug the
machine.
2. Remove the extension table and open the looper
cover.
3. Push the cutting width adjusting dial to the right
as far as it will go, then, move the needle plate
setting knob to the standard position or "R" (for
rolled hemming) position.
4. Close the looper cover and attach the extension
table.
q
Chaining finger
w
Needle plate setting knob
e
Standard position
r
Cutting width adjusting knob
(A) Standard Serging
* The chaining finger is located beside the needle
plate as shown in diagram (A) for guiding the flat
edge of the fabric for overlock sewing.
q
Chaining finger
w
Needle plate setting knob
e
Standard position
(B) Rolled Hemming
* Pull the needle plate setting knob toward you
from
Standard position
of the fabric will be rolled for hemming, picot
edging and narrow hemming sewing.
q
Chaining finger
w
Needle plate setting knob
e
Guide line R
734D Owners Manual/ User Guide
Janome Serger 734D
to "R" position, so the edge