How To Use The Needle Threader - Janome MyLock 734D Libro De Instrucciones

Janome 734D Instruction Manual
o
u
4, 5, 6
7, 8, 9, 10
1, 2, 3
4
y
5
www.toews.com
50
r
t
i
!0
y
t
r
q
w
e
t
4, 5, 6. After passing through the front cover thread
guide (1), pass the thread from the bottom of
the front cover thread guide (2) and the
take-up lever cover from right to left.
7. Guide the thread over the front cover thread
guide (3).
8. Insert the thread into the right slot of the needle
thread guide plate.
9. Raise the needle to its highest point and pass
the thread through the needle bar thread guide
from left to right.
10. Thread the right needle from front to back and
pull the thread about 10 cm (4˝) from the eye of
the needle to the back under the foot.
r
Front cover thread guide (1)
t
Front cover thread guide (2)
y
Take-up lever cover
u
Front cover thread guide (3)
i
Needle thread guide plate
o
Needle bar thread guide
!0
Right needle

• How to use the Needle Threader

* Turn off the power switch when you use the
Needle Threader.
* Do not use other than for the threading or
replacement of the needle.
1. Hold the stem of threader with the triangle mark
up. Guide the thread to insert it into the Y-groove
of the nib from right to left.
2. Place the V-groove over the needle just above the
needle eye. Make sure the thread does not slip
out from the Y-groove.
3. Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
4. Push the stem so that the threader pin comes out
through the needle eye with a loop of thread.
5. Remove the threader from the needle slowly,
leaving the thread loop behind the needle eye.
Then pick the loop with the hook to pull out the
end of thread to the back.
q
Stem
w
Triangle mark
e
Y-groove
r
Thread
t
V-groove
y
Hook
734D Owners Manual/ User Guide
Janome Serger 734D