Range Hood Care - ELICA ESN130 Guía De Instrucciones Para Instalación

ENM230 and ENM236 Series Models Control and features:
Operating the light
The On/Off light button controls both lights. Press once for On and again for Off.
Operating the blower
The BLOWER SPEED buttons turn the blower on and control the blower speed and
sound level for quiet operation. The speed can be changed anytime during fan
operation by pressing the desired blower speed button. Press the BLOWER OFF
button a second time to turn the blower off.
CLEANING
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter before
operating the hood. Reinstall grease filter correctly and replace the
screw in the vent system.
Exterior Surfaces:
IMPORTANT:
Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels. To avoid damage to the stainless steel, do not use
cleaners that contain chlorine.
Cleaning Method:
■ Rub in direction of grain to avoid scratching or damaging the
surface.
■ For stainless steel models, use a special stainless steel
cleaner and polish.
■ Liquid detergent or all-purpose cleaner: Rinse with clean water
and dry with soft, lint-free cloth.
Glass cleaner to remove fingerprints.
Metal Grease Filter (ESN, EFS and ERS Series Models)
For ducted installations:
Remove screw from the grease filter retainer.
1.
2. Turn the grease filter retainer to release filter.
Wash metal filters as needed in dishwasher or hot detergent
3.
solution.
4. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
A

RANGE HOOD CARE

A. Filter retainer
11
Replace screw in the grease filter retainer
5.
For non-ducted (recirculation) installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter. For
information on ordering, see the "Accessories" section.
To replace filter:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the grease filter retainer.
Metal Grease Filter (For ENM Series Models)
For ducted installations:
1. Press the grease filter retainer to release filter.
Wash metal filter as needed in dishwasher or hot detergent
2.
solution.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, push down the filter
retainer to secure filter to range hood.
B
B
A C D
A. On / Off light button
B. Blower Off and Speed minimum button
C. Blower speed medium button
D. Blower speed maximum button
A. Halogen lights
B. Grease filter retainer
A
C. Grease filter
C