ELICA ESN130 Guía De Instrucciones Para Instalación página 8

1. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
A. Keyhole slot
Use ¹⁄ " (3 mm) drill bit and drill 4 pilot holes as shown.
2.
8
A. Drill pilot hole
3. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot
holes. Leave about ¹⁄ " (6.4 cm) space between screw heads
4
and cabinet to slide range hood into place.
Remove transition knockouts depending on your model.
4.
A. Round vent knockout
B. Top rectangular vent knockout
C. Rear rectangular vent knockout
Round vent system installations - Remove top rectangular
and round vent knockouts.
Rectangular vent system installations - For roof
installations, remove the top rectangular vent knockout. For
wall installations, remove the rear rectangular vent knockout
Non-ducted (recirculating) installations - Do not remove
any knockouts.
5. Remove metal grease filters. See the "Range Hood Care"
section. For the ENM series models, first remove the lateral
panels
NOTE: You will have 3 1/4" x 10" (8.3 x 25.4 cm) rectangular
vent connector inside your range hood. Some models are
recirculation (non-ducted only) and will not have vent
connector.
6. Remove the 3-1/4" x 10" (8.3 x 25.4 cm) rectangular vent
connector attached with screws or taped on the inside your
range hood.
A
"
(6.4 mm)
A
B
C
models:ESN
EFS
ERS
A. Screws
B. 3 " X 10" (8.3 X 24.4 cm)
rectangular vent connector
model: ENM
A
For round installation: Install 7" (17.8 cm) round vent mounting
7.
plate and damper or 3 1/4" x 10" (8.3 x 25.4 cm) vent
connector, depending on your vent system installation.
(Purchase as an accesory).
8
A
A
A. Lateral panels
B. 3-1/4" x 10" (8.3 x 25.4 cm)
rectangular vent connector
B
A
A. 7" (17.8 cm) Round damper
B. Sheet metal screws
B
C. 7" (17.8 cm) round vent mounting plate
D. Round vent knockout
C
E. Rectangular vent knockout
D
E
B