Calibration; Error Codes - Baxtran SMC Serie Manual De Usuario

7. CALIBRATION

000
If display show any error message, please re-calibrate the scale again.

8. ERROR CODES

ERROR MESSAGE
Err 4
--Ol--
LO-BAT
FAIL
ERR 17
ERR 6
Press ON/OFF key to turn ON the Scale;
Press TARE key during that start up until display will be shown P1---;
Then input password,the default password is 000;
Press G/N key to move the active digit;
Press TARE key to increment a digit;
Press ZERO key
to confirm, display will shows
Press calibration switch,
Press ZERO key
to enter calibration, display shows
Empty the hook,when the
confirm, display will show calibration weight value;
You can change this weight value, using
using key to move the active digit right,using
Press Zero key to confirm;
LOAD
Display show , add calibrate mass weight on the hook.
When the indicator above STABLE
PASS
show ,it will be self-checking and back to normal weighing mode.
DESCRIPTION
Zero setting error
Over range
Low battery indicator
Calibration Error
Tare out of range
A/D value out of range
F0 cal
;
the switch is locating below the housing;
Unload
indicator above STABLE
key to clear the active digits ,
key to increment a digit;
appears, press
USERS GUIDE SMC
;
appears, press key to
key to confirm,display
SOLUTION
Zero setting range exceeded due to
switching on.(4%max)
Make sure platform empty.
Remove the load.
Re calibrate
Please charge the battery
Check the test weights & Re calibrate
Minus weight or overload. Remove
the load and restart scale again.
Make sure platform empty and check
the pan is installed proper. Check the
load cell connectors.
EN EN
35 35