Jøtul F 370 Serie Manual De Instalación, Utilización Y Mantenimiento página 10

ENGLISH
Fig. 6
2. Remove rack and rear plate in the base. Check that the handle
in the external air vent (fig. 4D) is in the foremost position.
3. Assemble the base with the burn chamber with the aid of
the 4 screws (M8x30 mm) from the screws bag (fig. 4 A).
4. Get assistance and carefully lift the product up.
10
Fig. 7
5. Adjust the product with the help of the 4 adjusting screws
(fig. 7 C).
6. Draw the flexible hose through the hole and fasten it to the
outlet with the aid of a hose clip. N.B. Make sure that the
hose is long enough to avoid any joints.
7. The base area must be protected from heat radiation from
the product with the aid of the accompanying heat shield
(fig. 7 A). Fasten this with the 2 screws as shown in fig. 7 B.
8. Reassemble the the rack and the rear plate in the base.