Jøtul F 370 Serie Manual De Instalación, Utilización Y Mantenimiento página 14

ENGLISH
Jøtul F 379 - with three legs
NB! If connecting the flex hose through a hole in the floor, do not
knock out the removable cover plates (fig. 21 A).
Fig. 21
1. If connecting a flex hose (Ø 100 mm) for external air supply
to the external air vent (fig. 4 C) beneath the burn chamber,
first drill a hole (fig. 21 A) in the removable cover plates before
they are knocked out. NB! Place the parts on a suitable surface
before the cover plates are knocked out.
Fig. 22
2. The accompanying heat shield (fig. 22 A) should be used to
protect the base from the heat radiating from the product.
Secure this first with a screw (fig. 22 B).
3. Secure the brace (fig. 22 C) loosely into place with a screw
(fig. 22 D).
4. Attach the base to the burn chamber using the 4 screws
(M8 x 30 mm) from the bag of screws (fig. 4 A).
5. Screw the legs together at the back edge using 2 screws that
are in the screw holes (fig. 22 E).
6. Secure the brace (fig. 22 C) into place with a screw (fig. 22 F)
and nut at both ends.
7. With the help of another person, carefully raise the product.
8. Level the product using the 4 adjustment screws (fig. 22 G).
9. If the legs are not properly aligned, loosen the screws (fig. 22 F)
on each side. Adjust the legs and tighten the screws again.
10. Tighten the screw (fig. 22 D).
11. Pull the flex hose through the hole and attach it to the outlet
using a hose clip. NB! Make sure the hose is long enough so
that joints are not necessary.
14
Fig. 23
12. Place the cover (fig. 23 A) into place. Make sure that the pin
(protrusion) B is facing down.
4.3 Chimneys and flue pipes
• The fireplace can be connected to a chimney and flue
pipe approved for solid fuel fired appliances with flue gas
temperatures specified in «2.0 Technical data".
• The chimney's cross-section must be at least as big as the
flue pipe's cross-section. See «2.0 Technical data» when
calculating the correct chimney cross-section.
• Several solid fuel fired appliances can be connected to the
same chimney if the chimney's cross-section is sufficient.
• Connection to the chimney must be carried out in accordance with
the installation instructions from the supplier of the chimney.
• Before making a hole in the chimney the fireplace should be
test-mounted in order to correctly mark the position of the
fireplace and the hole in the chimney. See fig. 1 for minimum
dimensions.
• Ensure that the flue pipe is inclined all the way up to the chimney.
• Use a flue pipe bend with a sweeping hatch that allows it to
be swept.
Be aware of the fact that it is particularly important that
connections have a certain flexibility in order to prevent
movement in the installation leading to cracks.
Chimney draught; See «2.0 Technical data». If the draught is
too strong you can install and operate a flue damper to control
the draught.
Assembly of flue pipe with top outlet
The product is supplied from the factory with the smoke outlet
mounted for top outlet.
1. Put the top plate (fig. 3 C) on the product.
2. Obtain assistance in lifting the top grate (fig. 3 A) and holding
it up while the flue is fastened.
3. Thread the flue pipe through the grate of the top plate and
place it on the smoke outlet of the top outlet.
4. Tighten well with gasket.