Jøtul F 370 Serie Manual De Instalación, Utilización Y Mantenimiento página 15

Assembly of flue pipe with rear outlet
The product is supplied from the factory with the smoke outlet
mounted for top outlet. If you want a rear outlet, do the following:
1. Place the product in correct position (fig. 1).
Fig. 24
2. When changing to rear outlet, the smoke outlet (fig. 24 B) is
unscrewed from the top outlet.
3. Unscrew the cover for the rear outlet from the inside of the
burn chamber (fig. 24 A).
Fig. 25
4. Place the gasket on the end of the flue pipe (fig. 25 A).
5. Mount the smoke outlet (fig. 25 B) on the end of the flue pipe
that is fitted with the gasket.
6. Mount the flue pipe and smoke outlet from the inside of the burn
chamber and attach the smoke outlet using M8x30 mm screws.
N.B. If the flue pipe is longer than 350 mm it has to be assembled
into the smoke outlet from the outside of the product.
7. Fasten the cover to the top outlet (fig. 24) with the screws
that fastened the smoke outlet.
N.B. It is important that the joints/flue pipes are completely
sealed. Air leaks can prevent the flue pipe from functioning
properly.
4.4 Mounting of the product
Fig. 26
1. Place the baffle plate with the bar in the groove on the ribs
(fig. 26 A).
2. Move the base plate through the opening and place it on
the bottom.
ENGLISH
15