Jøtul F 370 Serie Manual De Instalación, Utilización Y Mantenimiento página 11

Jøtul F 373 - pedestal
Important! If the rotating set is to be assembled, this must be done
now before the pedestal is fastened to the hearth. See assembly
instructions which accompany the rotating set.
Fig. 11
1. Adjust the product with the help of the 3 adjusting screws
(fig. 11 A).
2. Assemble the pedestal to the hearth's bottom plate with the
aid of the 4 screws from the bag of screws ( (fig. 4 A).
3. If the external air supply via the external air vent is to be used,
the flexible hose, 100 mm diameter, is connected to the vent
on the product (fig. 4 C) now.
4. Push the handle in the external air vent to the foremost
position (fig. 4 D).
5. Fasten the hose to the external air vent with the aid of a
hose clip. N.B. Make sure that the hose is long enough to
avoid any joints.
6. If the external air is to be supplied through the floor, place the
flexible gasket (fig. 11 B) around the hose, 100 mm diameter,
that is drawn through the hole in the floor. Note! The hole is
in the center of the pedestal/flue pipe.
7. Push the handle in the external air vent to the rear position
(fig. 4 E).
8. Get assistance and carefully lift the product up and place it
directly above the external air supply.
Important! Check that the handle in the external air vent is in
the foremost position if the external air is not to go through
the pedestal.
Jøtul F 374 - Cast iron leg
If external air supplied via the external air vent is to be used,
connect a flexible hose, Ø 100 mm, to the external air vent
(fig. 4 C) on the product.
Installation with external air
1. Push the lever on the external air vent to its forward position
(fig. 4 D).
2. Attach the hose to the external air vent using a hose clip.
NB! Make sure the hose is long enough to avoid any joints
being necessary.
Fig. 12
3. Move the cast iron leg towards the burn chamber as the
external air hose is passed through the leg and, if appropriate,
through the opening in its back (fig. 12).
Fig. 13
4. Attach the base to the burn chamber using the 4 screws (M8
x 30 mm) from the bag of screws (fig. 13 A).
5. With the help of another person, carefully raise the product
and position it correctly over the external air supply.
ENGLISH
11