Sun Microsystems Fire 880 Manual De Montaje página 7

The kit contains a plastic bag holding 10-32 screws (black in color) and M4 screws.
You will use these screws to install the tray assembly and server into the cabinet.
The following figure shows the screws at actual size.
10-32 screw M4 screw
(Black in color)
Any screws not used in the rack installation are spares.
Note – Bar nuts are required (but not included) for non-threaded cabinets. See the
cabinet instructions for more information.
What Next
Go to Chapter 2 and complete the procedures for installing the server into the
cabinet.
Getting Started en-3