Sun Microsystems Fire 880 Manual De Montaje página 28

2. Extend the tray all the way forward.
Standing in front of the cabinet, grasp the tray handle and pull the tray toward you
until it stops.
Caution – Do not place your fingers on the tray or under the server while you are
!
lifting the server and positioning it on the tray.
3. Place the server on the tray.
a. Lift the server (two persons on each side of the server) by the lifting handles
that you installed in "Preparing the Server" on page en-8.
b. Position the server on the tray so that the front of the server is at the front of
the tray and the back of the server is at the back of the tray.
4. Adjust the server on the tray until the four holes on each side of the server align
with the four holes in the tray assembly.
Tray
en-24 Sun Fire 880 Server Rackmounting Guide • October 2001
Align the four
screw holes on
the tray with
the four screw
holes on the
server.