Sun Microsystems Fire 880 Manual De Montaje página 27

Installing the Server Into the Tray
Assembly
1. Be sure the cabinet is stabilized so that the cabinet cannot move or tip forward
when the tray is extended and the server is placed on the tray.
If there are feet beneath the cabinet to prevent it from rolling, be sure the feet are
fully extended downward to the floor.
Stabilize the cabinet using the stabilizing mechanisms provided with the cabinet.
See the instructions provided with the cabinet.
Caution – Before you slide the tray out, be sure the cabinet is stabilized so that it
!
cannot move or tip forward. See the cabinet documentation for information about
stabilizing the cabinet.
Stabilizers
Caution – Do not attempt to lift the server until you remove all CPU/Memory
!
boards, all power supplies, all CPU fan trays, and all I/O fan trays. Once these
components are removed, four persons are required to lift the server. See "Preparing
the Server" on page en-8 for information about removing these components.
Some cabinets may be equipped with
stabilizers or bolt-down mechanisms.
See the cabinet documentation for
stabilizing instructions.
Installing the Server Into the Cabinet en-23