Bushnell 119519 Manual De Instrucciones página 25

Using the tripod socket: The camera is equipped with a socket at the
bottom end to enable using the included wall mount, a standard tripod,
or other mounting accessories with a standard 1/4-20 thread (see next
page).
To test whether the Surveillance Cam can effectively monitor the area you
choose, this test is recommended to check the sensing angle and monitoring
distance of the Surveillance Cam. To perform the test:
• Switch the Surveillance Cam to the SETUP mode.
• Make movements in front of the camera at several positions within the
area where you expect your intended subjects to be active. Try different
distances and angles from the camera.
• If the motion indicator LED light blinks, it indicates that position can be
sensed. If it does not blink, that position is outside of the sensing area.
The results of your testing will help you find the best placement when
mounting and aiming the Surveillance Cam. The height away from the
ground for placing the device should vary with the intended main photo
subject's size appropriately. In general, 3 to 6 feet is preferred.
You can avoid potential false triggers due to temperature and motion
disturbances in front of the camera by not aiming it at a heat source or nearby
tree branches or brush (especially on windy days).
Switching ON the Camera
Once you switch to the ON mode, the motion indicator LED (red) will blink
for about 10 seconds. This gives you time to close and lock the front cover
of the Surveillance Cam and then walk away. During this time, the motion
indicator LED will blink red continuously. After it stops blinking, the PIR
is active, and any motion that is detected by it will trigger the capture of
photos or videos as programmed in the SETUP Menu. Be sure you have
read the descriptions of the Capture Number, Video Length, Interval and
Sensor Level parameters. Please note, the PIR is strongly sensitive to
ambient temperature. The greater the temperature difference between the
environment and your subject, the farther the possible sensing distance. The
average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the following:
• Are the batteries inserted/connected with correct polarity and is the
power level is sufficient?
25