Kenmore 75990 Manual De Uso página 32

Proper c areandcleaning a reimportant soyourrange will
giveyouefficient andsatisfactory service._ Follow these
directions carefully i ncaring forittohelpassure safeand
proper m aintenance
BE SURE ELECTRICAL POWER IS DISCONNECTED
BEFORE CLEANING ANY PART OF YOUR RANGE.
Sealed Burner Assemblies
(on some models)
I AUTION: DoNOT O PERATE THE
BURNER WITHOUT ALL BURNER PARTS AND
DRIP PANS (IFSO EQUIPPED)IN PLACE.
Grate
Burner cap
Drip pan
(on some models)
, Burner head
Electrode
Turn all controls off before removing burner parts
and drip pans (if so equipped).
The burner grates, caps, heads and drip pans (if so
equipped) can be lifted off, making them easy to clean,.
The electrode of
the spark igniter is
exposed when the
burner head is
removed When one burner is turned to LITE, all the
burners spark,_Do not attempt to disassemble or'
clean around any burner while another burner is on
An electric shock may result, which could cause you
to knock over hot cookware.
Burner Heads
(on sealed burners only)
NOTE: Your burner heads and caps vary in
size, so remember their size and location before
removing them Replace them in the same location
after cleaning_
For proper ignition,
make sure the small
hole in the section that
fits over the electrode is
kept open, A sewing
needle or wire twist tie
works well to unclog it.
The slits in the burner heads of your range must
be kept clean at all times for an even, unhampered
flame.
You should clean the surface burners routinely, especially
after bad spil!overs, which could clog these openings
To remove burned-on food, soak the burner heads in a
solution of mild liquid detergent and hot water for-20-30
minutes For more stubborn stains, use a toothbrush,
Before putting the burner head back, shake out excess
water and then dry it thoroughly by setting
it in a warm oven for 30 minutes_
Replace the burner heads
and caps Make sure that
the heads and caps are
replaced on the correct
size burner. There is one
small, 2 medium and
one _arge cap.
After cleaning, make sure
the slot in the bumer head is
positioned over the electrode
Burner Caps
(on sealed burners only)
Lift off when cool. Wash burner caps in hot, soapy water
and rinse with clean water. You may scour with a plastic
scouring pad to remove burned-on food particles..
Dry them in a warm oven or with a cloth_on't
reassemble them wet. Replace the burner caps.
Make sure that caps are replaced on the correct size
burner: There is one small, 2 medium and one large cap,.
Smalt
Medium
Large
Left Drip Pan Right Drip Pan
Medium _ _ Small
Medium Large
Front of Range
32