Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 9
Installing the Anti=Tip Device
WARNING:
• Range must be secured with an approved Anti-Tip
device.
• Unless properly installed, the range could be tipped
by you or a child standing, sitting or' leaning on an
open door:
° After' installing the Anti-Tip device, verify that it is
properly installed and engaged by removing the
storage drawer, broiler drawer, or WARM-N-READY
drawer and inspecting the rear leveling leg
Make sure it fits securely into the slot..
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The installation of the Anti-Tip device must meet all
local codes for securing the appliance.
• The use of this device does not preclude tipping of
the range when not properly installed_
° If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB02X7909
These Anti-Tip device installation instructions are
for wood or concrete floor's and walls Any other
type of construction may require special installation
techniques to provide adequate fastening of the
Anti-Tip device to the floor and wall..
1. Locate the device against the rear wall and either the
right or left cabinet. If the countertop overhangs the
cabinet, offset the device from the cabinet by the
amount of overhang.. If there is no adjacent cabinet,
position the edge of the device at the desired location
of the range side panel
2. Use the device as a
ACeceetcabinet
er
Final Locating n| Range
template and mark 2
Side
Panel
\
hole positions or] the
::
..,WaU
Xales
wall and 2 hole
Weed
Floor
_...lj
positions on the floor.
Holes k ;I-_
Use either the wood or
Anti-Tip
1::_,_'_"
..))}J'
concrete
floor
set of
Device_Slde _ }_"
\_>_.J//'
positions, depending
__
concrete
FIoot
on your floor type,
Holes
RearLeveling
Leg of Range
3. For'wood construction, drill a 1/8"pilot hole in the
center of each of the pre-marked wood floor and wall
hole positions (a nail or awl may be used if a drill is not
available). Fasten the Anti-Tip device with the 4 screws
provided.
4_
For concrete construction, you will need four
W" x 11/2"lag bolts and four 1/2"O. D sleeve anchors
(not provided). Drill the recommended size hole for the
anchors into the concrete at the center of each of the
pre-marked floor and wall hole positions Install the
sleeve anchors into the drilled holes and then install
the lag bolts through the device Do not overtighten
the bolts.
Slide the range against the wall, and check for
proper installation by removing the storagew drawer,
broiler drawer, or WARM-N-READY drawer and
inspecting the rear' leveling leg.. Make sure it fits
securely into the slot on the Anti-Tip device..
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF THE CONTROLS ARE LEFT
IN THE OFF POSITION,
MAKE SURE THE FLOW OF COMBUSTION AND
VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED,
Converting to LP gas
(or converting back to natural gas from LP)
This range leaves the factory set for use with natural gas.
if you want to convert to LP gas, the conversion must be
petlormed by a qualified LP gas installer.
The conversion instructions, sticker and LP orifices
can be found attached to the range next to the
pressure regulator.
There is a second set of instructions included in the
envelope containing the product wiring diagrams on the
back of the range.. Keep these instructions and the
orifices in case you want to convert back to natural gas.
5O
Publicidad
Tabla de contenido
