Kenmore 75990 Manual De Uso página 49

To remove the oven bottom:
1. Remove the knuded screws holding down rear of the
oven bottom.
2o Grasp the oven bottom at finger slots on each side.
3, Lift the rear of the oven bottom enough to clear the
lip of the range frame, push it back, and then pull it
up and out.
STEP 8
Leveling the Range
1. Remove the storage drawer, broiler drawer, or WARM-
N-READY drawer
/
2.
3_
4,
,
6_
7.
Use a 3/_,,open-end or socket wrench to back out both
rear leveling legs approximately two turns
Use a 13/8"open-end or adjustable wrench to back out
the front leveling legs two turns..
Install the oven shelves in the oven, then position the
range where it will be installed.
Check for levelness by placing a spirit level or a
partially filled cup of water on one of the oven shelves.
If using a spirit level, take two readings--with the level
placed diagonally first in one direction and then the
other.
Adjust the leveling legs until the range is level.
After the range is level, slide the range away from the
wall so that the Anti-Tip device can be installed,
(continued next page)
49