Kenmore 75990 Manual De Uso página 51

PROBLEM
TOP BURNERS DO NOT LIGHT
OR DO NOT BURN EVENLY
POSSIBLE CAUSE
. Make sure electrical plug is plugged into a live power outlet,
• Burner holes on the side or around the top of burner may be clogged,, Remove
burners (on models with standard twin burners) or burner heads (on models
with sealed burners) or burner caps on spill-proof models, and clean them
with a sewing needle or twist tie Make sure you do not enlarge the holes++
On spill-proof models, check electrode area for burned+on food or grease,,
• Make sure the drip pans (on some models) are installed correctly,
BURNER FLAMES VERY • If range is connected to LP gas, contact the person who installed your range
LARGE OR YELLOW or made the conversion+
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
CLOCK DOES NOT WORK
OVEN LIGHT DOES NOT
COME ON
The oven gas shut-off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-off valve on standard twin burner models, raise
the cooktop and look for the gas shut-off lever at the extreme right rear corner.,
Follow the directions in box A or B that match your regulator type_
SURFACE LIGHT DOES
NOT WORK
Standard Twin Burner Models Standard Twin Burner Models
To check the oven gas shut-off valve on sealed burner models, remove the
storage drawer, broiler drawer or WARM-N-READY drawer and look for the gas
shut+off lever at the back of the range.
Sealed Burner Models
• Range electrical plug must be securely seated in a live power outlet,
Check for blown fuse or tripped circuit breaker,,
• See the Oven Control, Clock and Timer section,
• Bulb may be loose or burned out+
• Electrical plug must be plugged into a live power outlet,
oFluorescent bulb is loose or defective, Adjust or replace,,
• Switch operating light is broken Call for service+
(continued next page)
5!