Broiler Pan And Grid; Oven Bottom - Kenmore 75990 Manual De Uso

Broiler Pan and Grid
After broiling, remove the
broiler pan from the oven
or broiler compartment
(depending on your
model) Remove the grid _ _
from the pan.. Carefully _
pour out grease from the
pan into a proper
container Wash and rinse
the broiler pan and grid in
hot water with a soap-filled or plastic scouring pad..
If food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper towels or a dishcloth
Soaking the pan wilt remove burned-on foods,
The broiler pan and grid may be cleaned with a
commercial oven cleaner
Both the broiler pan and grid can also be cleaned in a
dishwasher
Do not store a soiled broiler pan and grid anywhere
in the range
CAUTION: Do not clean the broiler pan or grid in a
self-cleaning oven.
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier,
protect the oven bottom
from excessive spillovers
by placing a cookie sheet
on the shelf below the shelf
you are cooking on. "You
can use aluminum foi! if
you do not cover the whole
shelf.. This is particularly
important when baking a fruit
pie or other foods with a high acid content. Hot fruit
fillings or other foods that are highly acidic (such as
tomatoes, sauerkraut and sauces with vinegar or lemon
juice) may cause pitting and damage to. the porcelain
enamel surface and should be wiped up immediately
To clean up spillovers, use soap and water, an abrasive
cleaner or soap-fitted steel woof or plastic pad. Rinse well
to remove any soap before self-cleaning
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool. After cleaning, rinse the shelves with clean water
and dry with a clean cloth
NOTE: If the oven shelves are cleaned in the self-
cleaning oven, they will darken in color, lose their luster
and become hard to slide. To make the shelves slide
more easily apply a small amount of vegetable oil or
cooking oil to a paper-towel and wipe the edges of the
oven shelves with the paper-towel..
Surface Light and Starter
(on some models)
CAUTION: Do not touch the bulb with wet hands or
when bulb is hot. Never wipe the light area with a wet
cloth. Electrical power must be shut off if you have to
replace a bulb.
To replace the bulb:
1. With one hand at each
end of the hinged
canopy, grasp it by the
front edge and flip it up.
2. Remove the fluorescent
light bulb Replace the
bulb with one of the
same length and
wattage
3. Lower the canopy..
Canopy
Lift up
Starter
Light bulb
To replace the starter:
1. Open the canopy and
remove the bulb as explained above,
2,
Grasp the starter, turn it counterclockwise about one-
quarter turn and lift out Replace with one of the same
wattage.
3. Replace the bulb and lower the canopy.
34