Electrical Protections; Accessories / Options; Machine Use; Battery Check/Installation On Anew Machine - Nilfisk-Advance Terra 128B Manual De Uso

Rear wheels, driving
Electric motor
Weighted sound pressure
level (L )
pA
Batteries
Standard battery
Optional battery
Battery voltage
Usable battery capacity
Battery compartment size
Dust control and filter
Paper dust filter 5-10 µm
Electric filter-shaker (optional)
Vacuum in main broom
compartment
Diagram
Wiring diagram. See Figure U.

ELECTRICAL PROTECTIONS

Circuit breaker:
Side broom fuse:
Signal circuit fuse

ACCESSORIES / OPTIONS

In addiction to the standard components, the machine
can be equipped with the following accessories/op-
tions, according to the specific machine use:
1. Gel battery/ies
2. Main and side broom with harder and softer
bristles
3. Antistatic polyester or polyester BIA C dust filter
4. Electric filter shaker
5. Front wheel with brake pedal
6. Different skirt types
For further information concerning the optional acces-
sories, contact an authorized retailer.
146 0596 000(4)2004-02
ø 250 x 50 mm
(ø9.8x1.97 in)
600W (0.8 hp)
64 dB(A)
Lead, with acid
electrolyte
Gel, hermetic
12 V
Max. 240 Ah
398x262x283
(15.7x10.3x 11.1 in)
2 2
2 m (22 ft )
12V, 30W
4 mm H O
2
(0.63 in H O)
2
6, Fig. T
7, Fig. T
18, Fig. T

MACHINE USE

WARNING!
On the machine there are some decals in-
dicating:
- DANGER
- WARNING
- CAUTION
- CONSULTATION
Using this Manual, the operator must learn the meaning
of these symbols.
Do not cover these decals for any reason and in case
of damage, replace them immediately.
BATTERY CHECK/INSTALLATION ON A
NEW MACHINE
NOTE:
Battery charger must be connected to the
batteries for machine to function.
The machine needs a 12 V battery or two 6 V batteries
connected according to the diagram in Fig. T, 10.
The machine can be equipped in one of the following
ways:
a. A lead or gel battery installed on the machine and
ready to be used.
b. A lead battery installed on the machine but without
electrolyte.
c. Without a battery.
According to these conditions, follow the instructions as
described below.
a. Lead or gel battery installed on the machine
and ready to be used.
1. Open the hood (7, Fig. C) and check that the bat-
tery is connected to the machine using the appro-
priate connector (3, Fig. T).
2. Lower the hood and check that it is closed correct-
ly (the hood must be as shown in Fig. C).
3. Insert the ignition key (2, Fig. B) in the control pan-
el and turn it to the "I" position (without pulling the
lever 4, Fig. C).
If the green warning light (5, Fig. B) turns on, the
battery is charged and ready to be used.
Otherwise the battery needs to be charged (refers
to the procedure in the Maintenance chapter).
b. Lead battery installed on the machine but
without liquid electrolyte
1. Open the machine hood (7, Fig. C).
2. Remove the battery caps (8, Fig. T).
OPERATOR MANUAL
5