Electrical System - Nilfisk-Advance Retriever 4000B Instrucciones De Uso

Electrical System

The electrical system operates at 24V and is powered by four 6V, 244AH batteries connected in series. Never continue operating the rider sweeper until the
batteries run completely dead. When indicator 5, fig. 15 shows yellow, the batteries are starting to run down. The color of the indicator changes from green
to yellow to red as the level of the battery charge diminishes.
Green Light Batteries fully charged
Yellow Light Batteries partly charged
Red Light Batteries discharged
Caution !
Do not wait for indicator 5 to show red before recharging the batteries as this can cause rapid battery wear.
Proceed as follows to recharge the batteries:
1 Disconnect connector 2 from socket 3.
2 Connect plug 6 to socket 3.
3 Follow the charging instructions on the battery charger 4.
Fig. 15 - Battery Charger
Abb. 15 - Externes Batterieladegerät
4
37 - FORM NO. 56041325 / RETRIEVER 4000B
Fig. 15 - Chargeur de Batteries Exterieur
Fig. 15 - Carga-Baterías Externo
6
3
2
1
5