Kobalt SGY-AIR160NB Manual De Instrucciones página 21

CARE AND MAINTENANCE
9. After 3-5 minutes, remove each item and use a clean dry towel to wipe
off the entire item and inspect it for any remaining paint or dirt to wipe
remains.
IMPORTANT: To ensure all residue of material is removed from the part, use
a blow gun with an approved OSHA gun tip to blow any excess cleaning
solution off the part that a rag cannot get to.
If paint or dirt debris is still present, use a non-wire soft bristle brush and
brush the area.
NOTE: Soaking of parts may require longer to get all paint residue off the
part.
RE-ASSEMBLING SPRAY GUN
1. Screw the Fluid Nozzle into the face of the
spray gun by turning it clockwise, using the
provided wrench (8 mm) to tighten securely
(See Figure 1a, 1b).
NOTE: DO NOT OVERTIGHTEN.
8b
1a
1b
21
counterclockwise
Clockwise
Clockwise