Tabla De Contenido; Compressor Requirements - Kobalt SGY-AIR160NB Manual De Instrucciones

TABLE OF CONTENTS
Compressor Requirements.............................................................................2
Product Specifications....................................................................................3
Safety Information..........................................................................................3
Package Contents........................................................................................10
Preparation..........................................
Spray Gun Set-Up........................................................................................12
Assembly Instructions...................................................................................13
Operating Instructions..................................................................................14
Care and Maintenance.................................................................................18
Troubleshooting............................................................................................24
Warranty.......................................................................................................28

COMPRESSOR REQUIREMENTS

SMALL GRAVITY SPRAY GUN
3.3 40
@
SCFM PSI
Tool Requirements
Exigences relatives aux outils
Requisitos de herramientas
IMPORTANT: To operate correctly, this tool requires airflow of at least 3.3 cubic feet per
minute (SCFM) at 40 pounds per square inch (PSI) at the tool. Check the specifications
of your air compressor to be sure that it can support both the minimum SCFM and PSI
required. The air hose length could affect how much air pressure the tool is actually
receiving. You may need to adjust the air pressure higher on the air regulator to achieve
the max working pressure of 40 PSI.
SIPHON FEED SPRAY GUN
3.9 45
@
SCFM PSI
Tool Requirements
Exigences relatives aux outils
Requisitos de herramientas
IMPORTANT: To operate correctly, this tool requires airflow of at least 3.9 cubic feet per
minute (SCFM) at 45 pounds per square inch (PSI) at the tool. Check the specifications
of your air compressor to be sure that it can support both the minimum SCFM and PSI
required. The air hose length could affect how much air pressure the tool is actually
receiving. You may need to adjust the air pressure higher on the air regulator to achieve
the max working pressure of 45 PSI.
.........................................................11
2