Assembly Instructions - Kobalt SGY-AIR160NB Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1.Tighten female plug (not included), turning
clockwise with a wrench (not included) for
air tight connection (See Figure 1).
DO NOT OVERTIGHTEN.
NOTE: Use threaded sealant tape
(not included) on the male threading of the
air pressure regulator or the air inlet of the
spray gun.
NOTE: As an option, you can connect an Air
Pressure Regulator to the bottom of the
spray gun and then attach the female plug
to the bottom of the air pressure regulator.
DO NOT OVERTIGHTEN.
2a. Attach Paint Cup (B1) to Paint Gun (A1)
by screwing the paint cup clockwise onto
the paint inlet port located on the side of
the paint gun just behind the air cap.
DO NOT OVERTIGHTEN.
2b. Using the provided service wrench (H),
attach Paint Cup (B2) to Paint Gun (A2)
by screwing the paint cup onto the paint
inlet located on the bottom of the paint
the Air Cap (D2).
1
2a
B1
2b
13
A1
A2
B2