Operating Instructions - Kobalt SGY-AIR160NB Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
3. Depending on which spray gun you are
using, set the air compressor to the
specified pressure. Attach air line coming
from compressor to the spray gun.
NOTE: If you use the air pressure regulator,
adjust the air pressure so the gauge on the
regulator reads the recommended
pressure when the trigger is pulled.

OPERATING INSTRUCTIONS

NOTE
As an option, you can strain the paint that will be used in the Siphon Spray
Gun by using a supplied Paint Stainer (F).
Before using desired paint in the spray gun, spray a compatible thinner or
solvent through the gun to remove any contaminants and residues.
Thin paints properly in accordance with the paint manufacturer's
instructions before spraying.
Fill the paint cup (B1/B2) about 3/4 full and start the air compressor.
Set up a piece of cardboard or other scrap material to use as a target and
adjust for best spray pattern.
Test the consistency of the paint by making a few strokes on a cardboard
target. If paint still appears too thick, add a small amount of thinner. Do
not exceed paint manufacturer's thinning recommendations.
3
14
I2
I1
E