Installing And Aligning The Appliance - Thermador T18 Serie Instrucciones De Instalación

12. Installing and aligning the appliance
Never use a cordless screwdriver!
Risk of damage to the appliance.
- Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
- The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
- Do not bend the appliance against the anti-tip-
angles.
• Align the appliance with the furniture fronts.
Place marking-out level over the installation aid parts on
the door.
The installation aid parts on the door have been designed for
the following total thickness of furniture doors:
- s/4" (19 mm)
- 11/2" (38 mm)
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted subsequently.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:with open-ended
wrench 1/2" (SW13)
Rear:with 5/le'' (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of
11/2"
(32 mm) above
the floor.
1¼"
(32 mm)
Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
(11/4" / 32 mm).
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
• Align the furniture fronts with the spirit level.
26