Removing The Cover Frame For Service; Inserting The Language Tab - Bosch FMR-1000-RA Guía De Instalación Y Operación

10 en | Inserting the Language Tab
7.
Figure 5.2 Position of Mounting Screws and Earth Ground Screw
When the device is powered on, the system performs a selftest. The routine includes checking
of all interfaces, address switches, LEDs, LCD, buzzer, keys, current consumption, and lamp
test.
5.3

Removing the Cover Frame for Service

For removing the device's cover
frame when the annunciator unit
is already mounted, insert a
small flathead screwdriver in
each slot at the bottom or at the
top of the frame. Press up and
pull the cover frame off.
6

Inserting the Language Tab

For different language versions of LED and key lettering, use the tabs provided with the
FMR-1000-RA.
Figure 6.1 Inserting the Language Tab
1.
2.
3.
F.01U.078.097 | 3.0 | 2011.11
Place the cover frame onto the base along the top side. Press the bottom part until it
snaps into place.
1
Fire Gas Alarm Power
Supervisory Silenced Trouble
ACK
Insert the tab carefully in the slot at the top of the keypad.
Slide the tab down carefully until it is completely flush with the keypad.
For tab removal, carefully pull upwards at the strap.
Installation and Operation Guide
Figure 5.3 Removing the Cover Frame (after Installation)
2
Fire Gas Alarm Power
Supervisory Silenced Trouble
Gas Alarm
Silenced
Remote Annunciator
3
Fire Gas Alarm Power
Supervisory Silenced Trouble
ACK
Bosch Security Systems, Inc.